![]() There are different ways but like I said the longer straight edge will show the difference more readily. This procedure may or may not be covered in the owner's manual. This is tricky and may require several attempts. If the measurements are different then you must bring the trunnions into alignment with the miter slot, by loosening 3 bolts and pivoting on the one that is indicated. What do you see? Two different measurements or is it the same front and rear? By using a 12" or longer, straight edge you get more of a pronounced indication of the parallelism or lack there of between the two. You can use a calipers or another straight edge or a pair of dividers. Measure over to the miter slot from the right side of the straight edge front and rear without moving it, use magnets or tape it to the table if need be, securely up against the blade. If you have a steel graduated ruler say 12"or longer, place it between the blade and the right hand slot and try to get it either touching the teeth the same way or missing all the teeth and in the gullets, blade full up. Let's make sure that the blade is parallel to the miter gage slots.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |